Getting Started & Troubleshooting

Discussion List

• Why does filament sometimes get clogged in the hot-end?

  778 views 4 comments 0 points Most recent by ThingsNSchtuff June 2019Getting Started & Troubleshooting
• closing machine error

  363 views 1 comment 0 points Most recent by Samuel Pinches May 2019Getting Started & Troubleshooting
• JGaurora A5 doesn't connect to PC anymore

  823 views 9 comments 0 points Most recent by Spark July 2019Getting Started & Troubleshooting
• Printer not stopping heating

  114 views 4 comments 0 points Most recent by Jacob_Vaughan June 2019Getting Started & Troubleshooting
• Bought dial gauge but all the mounts are shit, any help?

  58 views 1 comment 0 points Most recent by cs2000 May 2019Getting Started & Troubleshooting
• Cura Extra Prime Amount

  80 views 0 comments 0 points Started by JetBoyTR May 2019 Getting Started & Troubleshooting
• With auto level probe, prints are skewed?

  1.2K views 17 comments 0 points Most recent by Laser8302 July 2019Getting Started & Troubleshooting
• Printer Continuing to print after cooling down?

  47 views 3 comments 0 points Most recent by Der_Muck May 2019Getting Started & Troubleshooting
• Replacement filament guide (bearing?)

  145 views 13 comments 0 points Most recent by Der_Muck May 2019Getting Started & Troubleshooting
• SOLVED: MINTEMP triggered, system stopped! Heater_ID: 0 (Printer randomly stopping mid print)

  1.8K views 1 comment 0 points Most recent by Samuel Pinches May 2019Getting Started & Troubleshooting
• Can't get files to read on any flash drive

  1.1K views 11 comments 0 points Most recent by Chris January 2021Getting Started & Troubleshooting