Getting Started & Troubleshooting

Discussion List

• Help To Get Better Prints?

  140 views 14 comments 0 points Most recent by Samuel Pinches August 2019Getting Started & Troubleshooting
• Fan Duct Screw

  218 views 1 comment 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• Problems with ghosting on print surface

  226 views 5 comments 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• JGAurora A5 stopping mid print without error even when pronterface is running&monitoring ((SOLVED))

  181 views 3 comments 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• Settings with Custom Firmware

  463 views 20 comments 0 points Most recent by Roberto April 2021Getting Started & Troubleshooting
• Lead screw vibrates/shakes while rotating

  563 views 4 comments 0 points Most recent by ToTo July 2019Getting Started & Troubleshooting
• A5 Stalls at various points during printing.

  64 views 2 comments 0 points Most recent by tay916 July 2019Getting Started & Troubleshooting
• positioning the print start

  31 views 1 comment 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• Troubles with printing position

  54 views 2 comments 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• leveling does not go to all four corners, stops in about 4" square, is it LCD program?

  38 views 2 comments 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting
• controls not working

  27 views 1 comment 0 points Most recent by Samuel Pinches July 2019Getting Started & Troubleshooting