Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Firmware for A3S Version 2 (2020) - planning
Samuel Pinches
Posts: 2,997Administrator
I just received the factory firmware files for the 2020/2019 update A3S printer. I have not added them to the wiki yet.
https://www.dropbox.com/sh/5ozb52qlqokd0qx/AAAhwSrl6xbBU1O9m71TTD9Ya?dl=0
I will look and see if it looks similar to the firmware for the A5S printers, hopefully it is. Then I can try build a firmware for this printer. I can't promise an ETA on this unfortunately, and it is tricky as I do not have one myself. I'm hoping the motherboard is the same as the A5S and A1.
https://www.dropbox.com/sh/5ozb52qlqokd0qx/AAAhwSrl6xbBU1O9m71TTD9Ya?dl=0
I will look and see if it looks similar to the firmware for the A5S printers, hopefully it is. Then I can try build a firmware for this printer. I can't promise an ETA on this unfortunately, and it is tricky as I do not have one myself. I'm hoping the motherboard is the same as the A5S and A1.
Post edited by Samuel Pinches on
Comments
Was the meaning to try it in the 3D printer?
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!