Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Covid Face Shield > gcode optimized for jgmaker magic
Leon
Posts: 4Member
Hello guys,
im printing some Face Shields design can be finde here:
https://www.prusaprinters.org/prints/25857-prusa-face-shield
i get some good results with petg 1,75 filiament. But i cant optimize the printtime. I always get about 4:00 hours to print 1 headband..
here is my gcode for the headband.. maybe its too hot with 230°C cause it produce some "hairs" but i think the result is good but way to SLOW..
Im using JGgreat 2.5.0 and tryed some changes in print/movespeed infill etc. but ill always get the same time.
Can u check the gcode- file or share a good and fast profile for Petg low res (0.25-0.3mm)?
thx Leon
im printing some Face Shields design can be finde here:
https://www.prusaprinters.org/prints/25857-prusa-face-shield
i get some good results with petg 1,75 filiament. But i cant optimize the printtime. I always get about 4:00 hours to print 1 headband..
here is my gcode for the headband.. maybe its too hot with 230°C cause it produce some "hairs" but i think the result is good but way to SLOW..
Im using JGgreat 2.5.0 and tryed some changes in print/movespeed infill etc. but ill always get the same time.
Can u check the gcode- file or share a good and fast profile for Petg low res (0.25-0.3mm)?
thx Leon
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!