Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Size of bed screws and knobs for A5?
Zisker
Posts: 1Member
My knobs are slipping from the screws on my printing bed. I would like to know if anyone knows the exact size of the bed screw and knob so i can purchase better parts.
Comments
Also, you might try lowering the Z-Endstop switch so you can lower the bed and not have the knobs fall off. its located inside the right vertical frame - white 3d printed plastic with two screws holding it to the frame. It has long slots so you can loosen the screws and move it up and down to adjust the Z-endstop height. Just lower it a couple mm and see if that helps.
You'll need to re-level the bed again - of course
stl file in https://www.thingiverse.com/thing:3001569
if you have any issue just leave a comment on the thingverse file and I will try to help
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!