More TMC problems

System

This discussion was created from comments split from: Official Firmware.

Hevilp

Yep, it already inside, too.

Why does the driver error appears from nowhere? I hope the new FW helps.

Samuel Pinches

What driver error? Can you post a screenshot?

Hevilp

Here:
https://jgmakerforum.com/discussion/118/y-driver-error-detected

Many weeks it worked fine, now I started a new longer print and it appears.
I only activated the things for dual extruder, but never used it, it just should print normal.

Samuel Pinches

I'm sorry, I thought you meant software driver for the CH340, I did not realise you were talking about the stepper drivers! It could be a loose wire perhaps? I haven't tried the TMC2130 with SPI myself sorry, I just use the A4988.

Hevilp

Its possible that the dual extruder install is to heavy and the tmc2130 overheat?
I checked the cables and all fine, I checked the cooling, and all is fine.

Samuel Pinches

It’s possible... maybe try a lower current setting?

Hevilp

I lowered it to 500 and it is still there, I will go back to old setting and test it..  

Samuel Pinches

Discussion continues here: https://jgmakerforum.com/discussion/118/y-driver-error-detected