Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
A5S - X axis problem starting print at wrong place
schoen4u
Posts: 1Member
Hi, instead of moving to it's intended position to start the print, x axis moves about 11 cm (4.3 inches) from home position and and the print starts at this position. I'm using the community software, but never had that problem before. Switching to the manufacturer's software did not have any effect. The info screen shows the x axis at position -6.0 when at home. I verified that the problem is not caused by the slicing software (Cura and JGAurora). As I can't open the firmware neither with the Arduino software nor with pronterface that doesn't connect to the printer, there is no way for me to check g-codes. Is there anybody who can help?
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!