Home JGAurora A5 & A3S Getting Started & Troubleshooting

Reset Firmware

Buenas,

Tengo una duda sobre el reseteo del firmware... si pulsamos el reset de la placa base, el firmware instalado hasta la fecha, se borra? Y si es así, es necesario de nuevo volver a instalar la versión básica o la última actualización completa?

Saludos y gracias.

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Hello,

I have a question about the firmware reset ... if we press the reset of the motherboard, the firmware installed, is it erased? And if so, is it necessary to reinstall the basic version or the last full update again?

Greetings and thanks.

Comments

  • michalko99michalko99 Posts: 125Member, 🌟 Super Member 🌟
    no. it will only make restart of processor. Nothing will be erased
    Thanked by 1Samuel Pinches
  • EspaitallerEspaitaller Posts: 4Member
    Buenas de nuevo,

    He reiniciado el firmware de la JGAURORA A5, pero cuando toca imprimir un diseño no hace absolutamente nada, solamente se escucha un pitido que se repite cada pocos segundos. La impresión sencillamente no se inicia y no para de pitar.

    Alguna idea de que puede ser el error?

    Gracias!

    ---------------------------------------------------------------------------------------------------------------------------------------------------------------------

    Hello again,

    I have restarted the firmware of the JGAURORA A5, but when I have to print a design it does absolutely nothing, only hear a beep that repeats every few seconds. Printing just won't start and won't stop beeping.

    Any idea what the error may be?

    Thanks!
  • michalko99michalko99 Posts: 125Member, 🌟 Super Member 🌟
    edited May 11
    filament runout sensor can be defective. It usually is, because it is crap. Disconnect it from LCD board and printer should work normally.

    it is better to cut cables, because connector is glued to pcb by hot glue shit. Do it with printer powered OFF!!!!

    sensor is the 3pin connector with 2 wires goin in...

    https://jgaurorawiki.com/_detail/filamentsensor.jpg?id=a5:disassembly


    Thanked by 1Samuel Pinches
    Post edited by michalko99 on
Sign In or Register to comment.