Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Enable Mesh Bed Leveling
kratas
Posts: 7Member
Installed 2.0H firmware. Leveled the bed, tested and it didn't work. Did this 4 times, still nothing. Tested several times. Followed the instructions and wondering what I am missing.
Comments
Welcome @kratas , best to just comment in one place for the issues you face.
Regarding bed levelling, are these the bed levelling instructions you're referring to?
Yes, that is the guide. I even reverted back to 2.0D to make sure and still nothing. The save to SD is not working as well for 2.0H. I have no other connection to the printer other than the SD card. I even tested the move axis and it starts out good and just launches to a gap at the other end of the bed. I have read some people found the solution but never mentioned the solution.
@kratas -- there is no settings savee to SD on 2.0H, the settings are saved on the CPU. I've added some troubleshooting steps to the end of the bed leveling instructions post. Could you please try those and report back? Thanks.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!