Homeโ€บ JGAurora A5 & A3Sโ€บ Getting Started & Troubleshooting

Bed Heater Wiring Connector

Would anyone know where to find this part (the 4 pin connector to the heated bed on an original A5) . The only thing I find in any of the wiki sources is a 6 wire connector bundled with the heated bed. I wouldn't mind to have the 4 pin connector with all the wires already in but I can do it myself if need be.
I have repaired/replaced the wiring several times but now the connector is starting to melt through in places.

Comments

  • michalko99michalko99 Posts: 153Member, ๐ŸŒŸ Super Member ๐ŸŒŸ

    hi. Do not use this connector. Solder wires directly on pins whose are on heatbed. Use some heat shrinking tubes for insulation and you are safe. This connection is underpowered by JG

    Thanked by 1Samuel Pinches
  • rhaub101rhaub101 Posts: 89๐ŸŒŸ Super Member ๐ŸŒŸ

    This is the way I did mine.

    Thanked by 1Samuel Pinches
  • michalko99michalko99 Posts: 153Member, ๐ŸŒŸ Super Member ๐ŸŒŸ

    Hi rhaub. I did it same way and since then, I never had any problems with bed

Sign In or Register to comment.