Pronterface, new problem with Jgaurora A5 "Thermal Runaway"

coffeeroast

Hallo,

i have an new problem with my printer.

The system stopps suddenly and pronterface give this

following fault message.

The problem is new and occurs only at one point when printing on.

The printer prints perfectly up to a certain point and after approx. 15 Min it stops at exactly the same position, the firmware is the community software which previously worked perfectly.

2Error:Thermal Runaway, system stopped! Heater_ID: 0

[ERROR] Error:Thermal Runaway, system stopped! Heater_ID: 0

Error:Printer halted. kill() called!
[ERROR] Error:Printer halted. kill() called!2

any Idea?

greets from Germany

Reinhard

G

M

T

DeutschEnglisch

DeutschEnglisch

Die Sound-Funktion ist auf 200 Zeichen begrenzt

Optionen : Geschichte : Feedback : Donate

Schließen

Samuel Pinches

@coffeeroast What temperature/ fan speed are you printing at? I suspect there is too much cooling on the nozzle, causing a drop in temperature that the printer is not able to keep up with.

coffeeroast

Hey, problem solved. There was a cable break of the thermistor cable in the lead to the board. Unfortunately, the error occurred very sporadically. And the measurements were all OK . It was in the black lead. I did not notice it until after I had changed everything else (thermistor, port on the Mainbord ...) Now everything is running again, also with the new Beta Community Software.
Thanks anyway for the help.