Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
My A5 stopped in the middle of a print, no problems found.
DIYglenn
Posts: 31🌟 Super Member 🌟
I had one print fail halfway with no warning.
The only special thing I can think of is that I had it connected to Repetier Host with a USB cable before printing, and unplugged and printed from a USB stick.
Everything was smooth until it just stopped with the nozzle on the print.
I re-sliced the (test-) model and power cycled the printer this time before printing again.
Did three prints afterwards without any issue.
I don’t like this, I’m afraid that the cables for the bed or similar have been worn/damaged and now could stop the prints at random times.
Anyone seen even this Issue?
The only special thing I can think of is that I had it connected to Repetier Host with a USB cable before printing, and unplugged and printed from a USB stick.
Everything was smooth until it just stopped with the nozzle on the print.
I re-sliced the (test-) model and power cycled the printer this time before printing again.
Did three prints afterwards without any issue.
I don’t like this, I’m afraid that the cables for the bed or similar have been worn/damaged and now could stop the prints at random times.
Anyone seen even this Issue?
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!