Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Loose x-axis coupling and other annoyances
delirii
Posts: 11Member
Hi,
I've noticed to things that may be problems on my A5:
- x-axis loose coupling. The extruder is locked on X-Axis between two (sorts of) spacers. I've noticed a slight movement of the extruder along the X-Axis between these spacers. About 1mm. It doesn't seem to be something normal for me... Have a look at this video to appreciate: (sec. 8, 9 and 14)
- the "cable organizer" on top of the extruder which contains both electric wires and the filament guide doesn't slide as expect the the extruder goes up. In fact, it blocks the extruder ascension because of not being properly guided. Am I the only one facing this problem? Any solution? I was thinking of a kind of long spring above the printer to help it go where it should...
Post edited by delirii on
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!