Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Change max retraction speed in community firmeare
compman2
Posts: 19Member
I was trying to get my cura to give accurate print times based on a linked article in the forum. I was looking up settings in the config.h file for DEFAULT_MAX_FEEDRATE and it appears that the extruder is set to a max speed of 25mm per second. I have seen recommendations for retraction speed for the A5 at 50mm per second. Is there a down side to setting this rate higher in the firmware to give more options?
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!