Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Wrong distance below 10mm on Z axis
Tim92
Posts: 12Member
On my A5 I've got a strange problem, I installed tmc2208 drivers and a BLTouch with the community firmware 1.1.8
leveling works fine and the first test prints are good.
Since today I got problems with the Z offset an couldn't get the the right distance to the bed. I noticed my printer moves around 2-3mm instead of 1mm below 10mm on the z axis.
if I use 0.1mm steps it moves almost 1mm and if it reach 10mm its normal and correct.
any ideas whats wrong?
leveling works fine and the first test prints are good.
Since today I got problems with the Z offset an couldn't get the the right distance to the bed. I noticed my printer moves around 2-3mm instead of 1mm below 10mm on the z axis.
if I use 0.1mm steps it moves almost 1mm and if it reach 10mm its normal and correct.
any ideas whats wrong?
Comments
After some restarts now it work correct but I didn't understand why.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!