Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Z Gantry Stiffener
RoLL
Posts: 5Member
The A5 is a good printer afterall.
A lot of good points and of course some not so good.
For me the first one one is the stiffness of the Z grantry. That's less than what we can find on a CR10 or a Tevo tornado and other clones by far.
A lot of good points and of course some not so good.
For me the first one one is the stiffness of the Z grantry. That's less than what we can find on a CR10 or a Tevo tornado and other clones by far.
So the aim of this design is to increase the Z gantry stiffness to reduce as possible layer offset / shifting.
For more information you can take a look here : https://www.thingiverse.com/thing:3199105
Thanked by 1Samuel Pinches
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!