Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Feeding filament into a JG Aurora A5
EldestYeti
Posts: 4Member
Printing Newbie here.
I am not sure how to load my given filament into my printer. I will stick in, and push the filament into it's respective hole, and it will stop at a certain point. I have looked online on YouTube, and I learned there is a black, hard to press button near the hole on the side, which should allow an easy flow of filament. This doesn't work. I also press the "In" button from the set menu and extruder menu, those don't work either.
Please help
I am not sure how to load my given filament into my printer. I will stick in, and push the filament into it's respective hole, and it will stop at a certain point. I have looked online on YouTube, and I learned there is a black, hard to press button near the hole on the side, which should allow an easy flow of filament. This doesn't work. I also press the "In" button from the set menu and extruder menu, those don't work either.
Please help
Thanked by 1FoxNovGolf
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!