Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Problem With Stringing Inside The Shell
JetBoyTR
Posts: 30Member
Post edited by JetBoyTR on
Comments
Set the retraction correct and when there is a problem with the infill, set the infillrate higher.
https://www.thingiverse.com/thing:909901
I test and set every filament I have with that test. I also had not so bad prints with some filaments but the test showed that it was heavy stringing. I would wonder that you get the test stringing free.
It can be that the infillrate is to high but first try to print the test.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!