Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Nozzle clean before printing

Hi,
is there a gcode that could clean the nozzle before starts printing?
I do have Gcode that prints a line before printing, but this is often not sufficient as the filament could lose from the bed and start to stick at the nozzle as a bubble. The bubble could get into the print especially when the nozzle turns into the direction where the bubble sticks.
I would like to have a script that does not just draw a line, it should print in all directions so that the bubble could fall off before the print starts.
Regards
testoli
is there a gcode that could clean the nozzle before starts printing?
I do have Gcode that prints a line before printing, but this is often not sufficient as the filament could lose from the bed and start to stick at the nozzle as a bubble. The bubble could get into the print especially when the nozzle turns into the direction where the bubble sticks.
I would like to have a script that does not just draw a line, it should print in all directions so that the bubble could fall off before the print starts.
Regards
testoli
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!