TMC2130 Upgrade failed

Hevilp

Hi, I followed all in the Video from dahai , but I get: >>>M906

SENDING:M906

X axis driver current: 0

Y axis driver current: 0

and 

>>>M122

SENDING:M122

  X Y

Enabled  false false

Set current 0 0

RMS current 1767 1767

MAX current 2491 2491

Run current 31/31 31/31

Hold current 31/31 31/31

CS actual  0/31 0/31

PWM scale 0 0

vsense  0=.325 0=.325

stealthChop false false

msteps  256 256

tstep  0 0

pwm

threshold  1581 1581

[mm/s]  100.02 100.02

OT prewarn false false

OT prewarn has

been triggered false false

off time  0 0

blank time 16 16

hysterisis

-end  -3 -3

-start  1 1

Stallguard thrs 0 0

DRVSTATUS X Y

stallguard

sg_result  0 0

fsactive

stst

olb

ola

s2gb

s2ga

otpw

ot

Driver registers:

 X = 0x00:00:00:00

 Y = 0x00:00:00:00

and 

>>>M122 S1

SENDING:M122 S1

axis:pwm_scale |status_response|

X:0 |0b0|  Y:0 |0b0|

X:0 |0b0|  Y:0 |0b0|

X:0 |0b0|  Y:0 |0b0|

X:0 |0b0|  Y:0 |0b0|

X:0 |0b0|  Y:0 |0b0|

X:0 |0b0|  Y:0 |0b0|

When I use the LCD do move the axis, nothing happens. Not even the z axis moves and I only changes x and y like in the Video 

Maybe the Y-cable connection is not good made by me?

I'm pretty sure, that the firmware upload is good, so it musst be the hardware or?

I did not change anything on the stepper driver itself  I got the v1.1

Hevilp

I reworked the y cables and now the debug seems good, full tests tomorrow... 

hugocz

Im having the same problem that you had when you say rework the cables what did you did exactly

Hevilp

At least 2 connection isnt good, Check all the solded connections, there should be a problem.

hugocz

ok thank you im gonna check it