A1 - Have to level it often

Spark

I seem to have to level this printer way too often.  Every 2-3 prints it is out of level.  I am not removing the bed. I am printing straight onto the glass.  Also as a sidenote, it has a layer shift issue every 2-3 prints.  The layer shift GREATLY.  

Samuel Pinches

Regarding the layer shift, which firmware are you using? Which axis is the shift in?

Are your bed levelling screws loose in some way? Printing at the same temperature each time? Same area of the bed?

Spark

Screws are tight.  Using stock firmware.  The layer shift is always right left.  Not front back so that is x? I am going to change the z- stop point higher cause the screws are tightened all the way down in a few places.  The weird thing is it printed just fine and now I need the bed lower then it can go..  HRM.  What clips are you guys using to hold the bed down..  I wonder if my clips are getting loose? 

Samuel Pinches

You can use masking tape too to hold it down if you have doubts?

Sounds to me like dodgy x bearings for sure.