Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Printing vases in "vase" mode. How is it set up for a JGAurora A5S
Kasey
Posts: 9Member
I'm new to 3D too. Have printed one aircraft ok, but can't get my A5S to print hollow vases. Unsure how to set the print routines to hollow out the vase. Tried both Cura and JGCreat, I ticked the spiral box and limited fill but no luck. Is there a "vase" mode somewhere I haven't yet found. Any ideas?
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!