Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
SKR 1.3 homing problems solved
Charly3
Posts: 35🌟 Super Member 🌟
Got a solution for a problem, a couple of other users run in too, so I´m posting it here.
My modified A5 with SKR 1.3 board started causing more and more trouble while homing. At last - whenever a mechanical endstop was triggered during homing - that axis got frozen.
The reason for this behavior: The connected raspberry with octoprint on had a damaged negative power supply cable. There was still some contact, but the cable had become that weak, that raspberry rerouted the negative power connection onto the USB Cable comming from SKR 1.3.
Cable repaired - endstops working fine again! So in case, be aware, that this kind of missbehavior might be caused by some external components.
Thanked by 1Samuel Pinches
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!