Home JGAurora A5 & A3S Getting Started & Troubleshooting

25mm layer shift !

Hi
i just checked on a 24+ hour i had going (12 pieces of the same design covering the whole bed) and the whole print (on every single piece) shifted 2 times for a total of 25mm and since i was somewhat close to the edge it started printing in midair outside the print bed area 😱

what could be the cause ? bad gcode ?

here is a picture of the layer shift

and here you can see it was printing outside of the print bed

Comments

  • michalko99michalko99 Posts: 153Member, 🌟 Super Member 🌟
    hello. at which speed are you printing? What is your travel speed and acceleration? Maybe a blob caught nozzle and during high speed movement it missed some steps and continued shifted..There is no position feedback, so it might happen. Which slicer are you using?
    Thanked by 1Samuel Pinches
Sign In or Register to comment.