Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
No calienta el nozzle / Nozzle don't heat
Espaitaller
Posts: 5Member
No sube la temperatura del nozzle. En la pantalla no hay variación de la temperatura (marca 59º y no sube).
He probado la resistencia en el tester y da continuidad. luego he probado directamente al voltaje y si calienta (llega a 200º según marca el tester).
Necesitaría un esquema eléctrico general de la impresora, si es que alguien lo tiene.
Gracias!
-----------------------------------------------------------------------------------------------------------------------------------------------------------
He probado la resistencia en el tester y da continuidad. luego he probado directamente al voltaje y si calienta (llega a 200º según marca el tester).
Necesitaría un esquema eléctrico general de la impresora, si es que alguien lo tiene.
Gracias!
-----------------------------------------------------------------------------------------------------------------------------------------------------------
The nozzle heat doesn't up. There isn't heat variation on the screen (it marks 59º and doesn't up).
I have tested the resistance in the tester and it gives continuity. Then I have directly tested the voltage and if it heats up (reaches 200º according to the tester).
You would need a general electrical schematic of the printer, if anyone has one.
Thank you!
Thanked by 1DonVicente
Comments
both hot ends and fan are switched by HY1403D mosfets, heated bed is switched by HY3403D
Can be done also by firmware, but you must have installed community firmware....
Does LED D2 lights up when you start preheating? If yes, measure voltage on HE0 terminal. If you get around 24Volts, continue measuring cable. It might be bent pin on chassis connector on right bottom side of printer
As I remember, A5 has standard galss type, so easily broken by overtightening( I have the experience )
Espaitaller. Take out NTC from heaterblock and show it here
I see some life on this forum last days..I am here everyday, but now its more live
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!