Home JGAurora A5S, A1 & A3S-V2 Getting Started & Troubleshooting

Enable Mesh Bed Leveling

Installed 2.0H firmware. Leveled the bed, tested and it didn't work. Did this 4 times, still nothing. Tested several times. Followed the instructions and wondering what I am missing.

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator

    Welcome @kratas , best to just comment in one place for the issues you face.
    Regarding bed levelling, are these the bed levelling instructions you're referring to?

  • krataskratas Posts: 7Member

    Yes, that is the guide. I even reverted back to 2.0D to make sure and still nothing. The save to SD is not working as well for 2.0H. I have no other connection to the printer other than the SD card. I even tested the move axis and it starts out good and just launches to a gap at the other end of the bed. I have read some people found the solution but never mentioned the solution.

  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    edited May 2021

    @kratas -- there is no settings savee to SD on 2.0H, the settings are saved on the CPU. I've added some troubleshooting steps to the end of the bed leveling instructions post. Could you please try those and report back? Thanks.

    Post edited by Samuel Pinches on
Sign In or Register to comment.