Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
LCD doesn't work
Mihawk
Posts: 5Member
Hi! I' have a problem with my jgaurora. At first start it works perfectly and the lcd was ok. Today, when I turned on my printer, I eard a long beep and in the LCD appeared 'booting' and nothing else... Someone have the reason to fix my problem?
Comments
You will then most likely see that it still does not work, and contact the support again...
Hello. i know the discussion is old, but..
I bought the Maker Magic and have a same problem. Unfortunately, the display goes off if the filament sensor is connected. When the sensor is unplugged, everything works very well, but the printer does not print anything because filament is not recognized. How can I solve the problem? Many Thanks. best regards
Sorry, wenn filament is inside. without filament anythong is ok
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!