Home JGMaker Magic

Holes in first layer

Infuze92Infuze92 Posts: 3Member
edited June 2021 in JGMaker Magic

I've tried to level, and re-level numerous times. I've tried to set up mesh leveling and no matter what I do I always seem to get these tears in the first layer whenever its filling in the solid part. Any suggestions on how to fix this? I never had this problem until recently.

Post edited by Infuze92 on

Comments

  • EuzzielEuzziel Posts: 15Member

    Check for:
    -clogging
    -extruder gear set screw
    -clean your extruder
    -check for any filament leaking
    -maybe print slowly, looks like the extruder cant catch up with the movement making it skip
    -tighten your extruder arm

  • Infuze92Infuze92 Posts: 3Member

    Thank you! I think I fixed it. I just got fed up with it and replaced all the springs, the extruder for an all metal one, and the ptfe tube just in case. With the new extruder it seems to be working much better.

  • Richy_TRichy_T Posts: 142🌟 Super Member 🌟

    Interesting. I get these too. Slowing down seems to help but not ideal.

  • EuzzielEuzziel Posts: 15Member

    go for more powerful extruder with stepdown gear ratio for better torque. BMG and Titan both works fine but may need to increase Esteps to around 400 depending which one you'd like, definitely need calibration. Direct or bowden setup with or without all metal hotend, you need to place that capricorn tubing flush with whatever it is touching..

Sign In or Register to comment.