Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

Back to Profile

Enrique Riri

My solution. I updated<img title="Image: https://jgmakerforum.com/uploads/editor/bl/x0lg2h08wt9x.jpg" alt="" src="https://jgmakerforum.com/uploads/editor/bl/x0lg2h08wt9x.jpg"> all my 3 printers…

Thanked by 1Samuel Pinches
My main experience : I had several differeent printers in the last 5 years and I spend hundred hours around trying tho get acceptable prints. I search to get a good printer with less spend time to fi…

Thanked by 1sasa
I agree the fact to shield the LCD cable. I made that too. Also the length of the cable is too long. that can increase interference and noise capture too. Another thing to take care: Shield of the US…

Thanked by 1Samuel Pinches
I suspect you had an issue with your head temp sensor. What happens, on the original sensor, one of the wire disconnect on soldered junction rear the screw of the head and makes a shortcut with the …

Thanked by 2sasa Samuel Pinches
Hi, First check the extruder temp is ok. If you don't reach the right temp: mini 190°C, you cannot attempt to run extruder motor.

Thanked by 1Samuel Pinches
Hi, after a lot of testing hours with TMC2208 and TMC2130, my personnal conclusion was; the extruder motor and filament mecanism are quite sensitive and requires a lot of attention if we want to be s…

Thanked by 1Samuel Pinches
<img title="Image: https://jgmakerforum.com/uploads/editor/nn/muhsgvm35rxn.jpg" alt="" src="https://jgmakerforum.com/uploads/editor/nn/muhsgvm35rxn.jpg">

Thanked by 1Samuel Pinches
Hi, I had similar issues with my USB port. Please upgrade your TFT firmware to v 3.03. If you have unofficial firmware, stay with old files but replace just mkstft28.bin. Issue solved for me.

Thanked by 1jirgel
So, seems firmware 3.03 of the LCD solved this issue with new TFT2.8 v4 delivered in standard with last A5 printers. The V3 was not available anymore. So, I just took the new .bin and stay with the o…

Thanked by 1Samuel Pinches
Seems there is a new firmware v3.03 just released. I will test it and update info...

Thanked by 1Samuel Pinches
Hi, My latest delivered A5 comes with version 4 of the TFT. However, with the same upgraded firmware to have mesh leveling, etc... All seems to work OK, except when the filament detection was activat…

Thanked by 1Samuel Pinches
Personnally, not yet tested SPI without endstops (seems in theory to work, but request candidates to validate). My thoughts and reads brings me the idea, it can be usefull for X/Y sensors axes, but n…

Thanked by 1Andrei Shekhau
Hi,
Had a lot of troubles upgrading to TMC 2130 v 1.1 using SPI, and after some hours, reads, tests, here are the MAJOR things to take care to success 100% this upgrade:

1st : Disconnect …

Thanked by 3klreese Werewolf Samuel Pinches
Yes, no PB. I used them on my A5 printer. Standard ones

Thanked by 2chilman408 RomainD