Toggle navigation
Categories
Discussions
Activity
🔨Firmware
🧰Starter Kit
💡Wiki
🛒Shop
Sign In
Home
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
Back to Profile
Zel
About
Username
Zel
Joined
January 2021
Visits
152
Last Active
May 2021
Roles
Member
Location
United States of America
Thanked
7
What model of 3D printers I own (optional):
JGMAKER MAGIC
Posts
24
Activity
Thanked
7
Discussions
2
Comments
22
that's your seam. what's your retraction settings? Z-raise per layer? which axis does the uneven side from? X or Y?
Thanked by
1
Samuel Pinches
adjust the Z-axis limit switch instead of putting pressure on the Y-axis rods by over tightening the thumbscrews
Thanked by
1
Samuel Pinches
i have an SKR 1.4 turbo, replaced all drivers with 2209s. Had no problem with it. XYZE stepper motors are all running great and quiet. if you feel underpowered, just adjust the current but dont go ab…
Thanked by
1
Samuel Pinches
check the ff:
-coupler screws for z rod
-check the x axis if squared to the gantry
-clean z rod
-calibrate z-axis. while doing so, calibrate XYZE since you're doing it.
-clean ext…
Thanked by
1
Samuel Pinches
Should be easy with a lot of troubleshooting.
HARDWARE:
~Depending on which board are you going for, there might be some modding with both hardware and software for the screen not unless you …
Thanked by
1
Samuel Pinches
how many amps does the hotend needs? ampacity should be the deciding factor. Silicone insulated wire should hold temp more than the common pvc coated wire. If you find that the current drawn by the h…
Thanked by
1
Samuel Pinches
yes.
you'll have to allow it in marlin.
Thanked by
1
Samuel Pinches