Toggle navigation
Categories
Discussions
Activity
🔨Firmware
🧰Starter Kit
💡Wiki
🛒Shop
Sign In
Home
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
Back to Profile
rhythmdave
About
Username
rhythmdave
Joined
June 2019
Visits
35
Last Active
October 2019
Roles
Member
Location
United States of America
Thanked
5
What model of 3D printers I own (optional):
JGAURORA A1
Posts
10
Activity
Thanked
5
Discussions
5
Comments
5
I had the same problem with scratching the bed. Turned out the hot end carriage wasn't level (x axis). Was able to level it by turning off printer and hand turning z axis motors by hand. After leve…
Thanked by
1
Samuel Pinches
Found the prob...
If you reference the bed with the X axis rods in the first pic you can see the left side is slightly lower than the right. My Z axis motors weren't in sync for some reason (???…
Thanked by
1
Samuel Pinches
Ok, bear with me here.
Installed the newest version of the custom A1 firmware. Set up a pi w/Octoprint...send job to Octoprint and get error, cannot complete bed leveling. So, checked firmware …
Thanked by
1
Samuel Pinches
Ok, so I'm new to this 3d printing thing and just wanted to make an observation. I know stuff like this is probably in post overkill by now but just had to share.
So I decided to print the ga…
Thanked by
1
Samuel Pinches
Thanks Samuel. That's what thought. Was just curious. So far having a blast learning the 3D world and I think I got a pretty good printer to do so. Getting ready to put the community firmware on i…
Thanked by
1
Samuel Pinches