Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

Back to Profile

sirhcwolf

Nope, I have zero issues with the 40W heater. Just have to PID tune.

Thanked by 1Samuel Pinches
<div>The clicking is typically the nozzle is too close to the bed in this scenario. I've found that I need more of a gap between the nozzle and the bed than a piece of paper. The clicking is ca…

Thanked by 2Samuel Pinches printcrafter
Coming soon to a Thingiverse near you, 5015 fan duct and shroud to mount it on.

Thanked by 1Samuel Pinches
Remixed by the designer of the shroud to dual output https://www.thingiverse.com/thing:4459494

Thanked by 1Samuel Pinches
<div> I feel like there's a thread missing, but i made a fan duct that is better suited for the Magic than https://www.thingiverse.com/thing:3891032.</div><div>
</div><…

Thanked by 1Samuel Pinches
I use a straight-edge razor scraper, it is just enough to get the print to pop off.

Thanked by 1Samuel Pinches
I suggest unscrewing the bolt holding the tension arm to the roller assembly, the plastic on mine cracked from the strain and couldn't hold the filament to the extruder gear. Replaced with an aluminu…

Thanked by 1Samuel Pinches
Ender 3 MicroSwiss clone on mine, no issues with mounting.

Thanked by 1Samuel Pinches
I'm with @"Samuel Pinches" , what values?

Thanked by 1Samuel Pinches
https://www.thingiverse.com/thing:4380692 i just uploaded. May take 24 hours to be visible as i just signed up.

Thanked by 3sergtm Nickstats Samuel Pinches