Home› JGAurora A5 & A3S› Getting Started & Troubleshooting
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

Weird First Layer Sometime

JayJoeJayJoe Posts: 34🌟 Super Member 🌟
edited October 2018 in Getting Started & Troubleshooting
Hi, I am getting this type of first layer recently - uneven extrusion(?). I am using CURA and may I know what setting I need to adjust to get rid of this?

Post edited by JayJoe on

Comments

  • itisnot_meitisnot_me Posts: 102🌟 Super Member 🌟
    edited October 2018
    did you update the firmware or is it stock? also what is your bed/nozzle temp?
    Post edited by itisnot_me on
  • JayJoeJayJoe Posts: 34🌟 Super Member 🌟
    I updated the firmware once I received the 3D printer around end of June. Bed temperature is 60 degC whereas nozzle temperature is 210 degC
  • itisnot_meitisnot_me Posts: 102🌟 Super Member 🌟
    sorry i am not any help but some people have lots of thoughts. https://www.reddit.com/r/3Dprinting/comments/42i5rz/why_are_there_waves_in_my_first_layer/

    sum up.
    over extrusion
    too hot (from above doubt it)
    Clean the bed
    too far/too close nozzle
    Maybe a little too fast. I print my first layer at 12mm and regular at 20-60. also use the squish method for the first layer

    I know that i had issues like that in the beta version but went away when i went back to the stable
    Thanked by 2Samuel Pinches JayJoe
Sign In or Register to comment.