Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
The Unofficial JGMaker 3D Printer Forum
A place for owners of the JGMaker & JGAurora 3D printers to share knowledge, collaborate on ideas, and help each other to get the most out of our 3D printers.
Category List
-
Released in the middle of 2018, the A5S and A1 feature an entirely new 32-bit motherboard. While less modifiable, these printers have better print quality compared to the A5, while keeping the same huge print volume. The 2nd version of the A3S was released in late 2019 using the same new updated 32bit motherboard - this version can be identified by the SD card slot on the front of the printer.360 discussions 2.3K comments Most recent: Adding BLTouch and Unified Bed Leveling to the A5S and A1 by pwelka October 2022
-
Released Nov 2017, the A5 and A3S are excellent reliable low-cost printers, that can be upgraded and modified to an amazing degree. The A5 has a print volume of a 300mm cube , while the A3S features a print volume of a 200mm cube.735 discussions 4.9K comments Most recent: Successfully upgraded to marlin 2.1 and TFT28 to BigTreeTech for using TMC2209 Drivers by Feepro January 16
-
In the budget printer category, the JGMaker is a great easy-to-use beginner printer delivering excellent print quality at an affordable price. Released early 2019.
122 discussions 519 comments Most recent: Magic Firmware Marlin 2.0 Error by Samuel Pinches January 2022
-
What would happen if the JGAurora A5 and a Creality CR-10 had a child? Released in early 2018, the JGAurora A5X fills that void, with an aluminium extrusion frame, and a separate electronics control box.
13 discussions 73 comments Most recent: Filament blockage in new heater block? by Stephen Todd April 2020