Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Octoprint + A5S
Hole23
Posts: 5Member
Hi. I have problems installing Octoprint on a JGAurora A5S. Every time I start a print, the RPI sends too many commands without waiting for the "ok"s. So it enters in "checksum error" and the printer sends "re-send command". Anyone installed Octoprint in a JG A5s successfully?
Comments
https://firmware.jgmakerwiki.com/
It is worth using octoprint you can access printer remotely, I am using astroprint application for that.
you can use cura addin to send file directly to printer.
few drawbacks Filament run out detection & Power outage detection not working on Marlin firmware.
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!