Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Gcode for pausing
loganddplus
Posts: 3Member
I have an A5S that prints fine and I’m trying to pause and embed some magnets. I have done it on other printers with success. I’m using the latest Cura slicer and I have tried all three pause at height and layer settings. The printer will pause and stick its tongue out. I also put the M17 code in to keep steppers engaged. The problem I’m having is that the printer only pauses for about 3 seconds and then resumes the print. I have put in code M0 S360 and M1 S360 and it does the same thing goes to the park place waits a few seconds and then gives me the bird and goes back to finish the print. I have pressed the pause button when it starts again and it goes off to the side but I want better access to the print for embedding magnets.
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!