Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
JGAurora A5 - Custom Marlin Firmware 1.1.8C Heatbed temperature is not riged adjusted
Christian
Posts: 6Member
I bought a used JGAurora A% and had some problems with the hotend heating first. After i changed the port in the firmware 1.1.8.c that worked right again. But now I have problems with the temperature of the heatbed. It starts with 72 degrees even ti has only 27 degrees on the bed. If I add temperature to 90 degrees it goes up to 41 degrees, but not more.
Comments
Unfortunately it is a common fault on these boards - happened to me - both the hot end and bed temperatures went wrong at the same time - I simply replaced the board, and everything was instantly perfect again - and the old board is now an arduino mega for use with other electronic projects
Aliexpress: http://s.click.aliexpress.com/e/bXQqiPB2
Amazon USA: https://amzn.to/3e33Q6R
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!