Glass Released from heat element

Hevilp

Hi,

Why does my heatbled is splitting up? On 1 corner the glass is not anymore hold by the heat element.

And beside, I got warping at 20% infill everywhere. 1 print before all was fine 

Hevilp

Yes I got huge warping  Imho the glass moved away from the heatbed. It is possible to use Some special glue to fix it? And why does it happend? 

Hevilp

Samuel Pinches

I’ve seen it happen to a couple of people unfortunately :-(
Maybe you can use some bulldog clips or picture frame clips in the meantime to hold it?

or perhaps see if these fit: https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fulk%2Fitm%2F173202555917

in the more recently produced A5, JGAurora is including clips installed to hold it tighter.

Hevilp

I used glue with -40 to 120 degrees. Till now it works