Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
A5 stops and freezes after a few seconds of printing
mgtowers
Posts: 3Member
Hi,
I hope someone can help me with my problem. JGAurora A5, community firmware 11-1-18.
After a few seconds of printing the printer stops and the display doesn't react anymore. Occurs also on print files that used to work fine. It seems to me like it always freezes on the exact same position. Heating nozzle and bed seems to work fine to me, stable temperatures while testing manual extruding, temperatures properly adjustable and displayed temperatures match ok with measured ones (with IR thermometer).
What do I need to do? Please let me know if I missed to provide crucial information in here.
thanks a lot upfront!
Comments
hi. For me, it was heated bed cable. It is badly designed by default. Printer stops when tempertature starts dropping, Maybe you should wiggle cable at bed side and look on underside LED during preheat. When bed is cold, LED is lit all the time until it reaches desired temperature,..This is thermal runaway protection, which does not give any output to user
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!