Home› JGAurora A5 & A3S› Getting Started & Troubleshooting
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

My printer won't go to home anymore.

eddymcflyeddymcfly Posts: 9Member
in Getting Started & Troubleshooting
Hi guys, I just received my printer in the mail today. I just got done setting it up and test my first print. after the print was done I decide to try and adjust my nozzle height. all i did was slightly move the sensor up and now my printer won't move across the x and z axis. any advice would be appreciated. thank you

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    When you press the home button for each axis, what happens?
  • eddymcflyeddymcfly Posts: 9Member
    edited October 2018
    The nozzle moves on the y axis, but there is no movement from the bed or the z axis. The message i get on simplify 3D if i remember correctly is “M105 busy processing” so far i have tried resetting the firmware but the problem still persists.
    Post edited by eddymcfly on
  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    edited October 2018
    Normally the axis will not move until they have homed. Can you please test your endstops. The command is M119 - enter this command each time while holding down each of the endstops in sequence.


    It could be a stepper driver fault? If the x and z axis are not working, turn off the printer, and try swap the x-axis stepper driver with the working one on the y-axis. See what happens then...
    Post edited by Samuel Pinches on
Sign In or Register to comment.