Home› JGAurora A5 & A3S› Getting Started & Troubleshooting
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.

A5 setep motor error

okanokan Posts: 5Member
edited November 2018 in Getting Started & Troubleshooting
Hello,
The thermistor input on the motherboard is damaged. I put the new thermistor on another input. I first installed the marlin software. There was no problem. Then I turned on the printer. I wanted to do the configuration, but I came across this error. Please help.(watch video)



Post edited by okan on

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    edited November 2018
    You can use pronterface to send gcode commands to help test this.

    1. Reset your eeprom - send M502 then send  M500.

    2. Then test your z endstop with M119. Make sure you see triggered when the z endstop is pressed (you can use your finger to press it) and that it says open, when the z endstop is not pressed.

    I hope that helps get you started.
    Post edited by Samuel Pinches on
  • okanokan Posts: 5Member
    Hi, I reset the eeprom. First M502 after M500. Nothing has changed. I checked the axes with M119. Pronterface say x_min: Triggered y_min:Triggered z_min:open z_probe:open I do not know what to do :((
  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    Try flash the community firmware 1.1.8.C.
Sign In or Register to comment.