Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
A5 even more problems now with community firmware?
davidgotmilk
Posts: 1Member
So originally my printer head was +-10C in terms of accuracy. I read that the community firmware would help. So i upgraded, and now it's 30C less than what is being reported. I have it set to 210C and it is registering as 180C with my laser thermometer. So I try to offset it, by choosing 240C so I can get 210 C in Cura. But now when I print it also defaults the print head to 215C. no matter what. Even if it's set to 240 or lower it will only go up to 215C, which when reading with the laser thermometer is actually 185C, and my printer is severely under extruding now. Is there anything I can do or some kind of unknown cura setting that is revert my temp to 215 that I need to change? Or should I just rollback to stock firmware.
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!