Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Heating problem...
elbico
Posts: 1Member
I have a problem with my printer, the nozzle and the bed arent heating... I have standards numbers with the nozzle, but the bed is stuck with strange numbers: 132/50 Can't figure it out... Solutions please ?
Comments
I could imagine the software deactivates heating because the bed is already way to hot (it thinks^^)
Can you use an ohm meter and measure the termistor under your heat bed at room temperature?
(Either on the Mainboard (pinout in the wiki) or you disassemble the heat bed (Da Hais Video) and measure at the connector)
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!