Marlin Software für den A5X klappt nicht richtig

gabrielsfall

Hallo,

ich habe heute die geänderte Marlinsoftware für den A5X hier aus dem Forum geladen und gemäß Anleitung installiert. Jetzt hab ich das Problem, das die Endstopschalter wohl nicht richtig erkannt werden. Der Drucker macht beim Homing seltsame Geräusche und das Heizbett bleibt Mittig stehen. Ich habe folgende Einstellungen geändert:

- #define EEPROM_SETTINGS // Enable for M500 and M501 commands (Additional Features)

- #define GRID_MAX_POINTS_X 4    // Don't use more than 7 points per axis, implementation limited. (Mesh)

Hat vielleicht einer ne Idee?

Lieben Gruß

Mario

Hello,
I have today downloaded the modified Marlinsoftware for the A5X here from the forum and installed according to instructions. Now I have the problem that the endswitch probably not be recognized correctly. The printer makes strange noises when homing and the heating bed stays in the middle. I changed the following settings:
- #define EEPROM_SETTINGS // Enable for M500 and M501 commands (Additional Features)
- #define GRID_MAX_POINTS_X 4 // Do not use more than 7 points per axis, implementation limited. (Mesh)
Maybe an idea?
Greets
Mario

Samuel Pinches

Hi Mario ( @gabrielsfall ),

Merry Chrismas

You can test the endstops using pronterface, and sending command M119. This should tell you if there is a problem with the endstop setting.

Cheers,
Sam

EspenB

Hi,

I had to update the main board on my A5X and need the marin firmware.  Unfortunaty I have not been able to locate it.  Where did you find the firmware?  

Philippe Rodier

Which firmware do you use ? 

Samuel Pinches

@EspenB Welcome - A5X firmware is on the wiki. https://jgaurorawiki.com/a5x