A5S

asterix007

Hi, I'm new here  a hearty hello to all here.

I bought an A5S in December, I am almost satisfied with the device except 
with black PLA I have violent problems ...
All other colors go very well, take that from E-Sun

1.) can you convert the A5 to auto beet levels?
2.) can you install a dual extruder above?
sorry for my english, googlanslator

Samuel Pinches

Hi and welcome @asterix007 !

Unfortunately, at this stage the A5S firmware cannot be modified easily, so major hardware modifications are not possible.

The A5S looks the same as the A5 on the outside, but the inside is very different.

Hopefully we will have an alternate firmware option for the A5S later this year...

asterix007

Hello,
many thanks for your response.
I thought this was nothing to do after all that I've read. could have been that you know there maybe more.

I'll stay tuned if there is something 

greeting asterix007

Samuel Pinches

Hi @asterix007 - I would like to see auto bed levelling on the A5S, but I cannot promise anything yet. We are making progress though:

https://jgmakerforum.com/discussion/394/planning-new-firmware#latest

From looking at the motherboard, a second extruder nozzle is not possible, without replacing the motherboard. A second extruder (single nozzle) may be possible.

asterix007

many thanks,

I always read with great curiosity ...

just hope that it will not be too expensive.

nice greetings from Austria

asterix007

Hello, is there a .stl fan duct for the A5s? 
or can I also take those from the A5? Unfortunately, 
I find nothing in the net for the A5 "s" 

Samuel Pinches

The A5 ducts should fit fine