Anyone Use Prusaslicer 2.0 with an A5s?

mgrabow

I wanted to experiment with Prusaslicer 2.0   Having issues getting it to play nice with my A5s.   I have selected "Marlin" as the flavor but I am not sure what else could be the issue.  Basically the bed and the hoot end do not set a temp when I print.  They just say 0 on each.  This also seems to jack up the processor needing a firmware reload to fix it...

Frezap

I use Cura but I have got PrusaSlicer set up and printed a calibration cube with it once.

I attached my configuration. If it works you can start from there.

mgrabow

Thanks, Ill give it a try

mgrabow

Still have the same issue.   Something in the g code never starts the process and it keeps it from starting even if I go back with a cure file.   

Spark

Let me try this later today.  I have the printer printing now  but when it finishes the print I will test it out! I have had good luck with a wide range of printers in slic3r pe

Spark

I have no problems printing.  Here is my config file. 

mgrabow

Thanks Ill give it a shot...