Home JGAurora A5 & A3S Getting Started & Troubleshooting

JGAurora A5 stopping mid print without error even when pronterface is running&monitoring ((SOLVED))

coolt5coolt5 Posts: 38🌟 Super Member 🌟
i just had the same problem with usb stick so i tried the usb cable and have the same thing.
so i tried to print using pronterface its self using usb cable and this what i get:

The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49   ( here printing just stopped for no reason )
(so i unplug the usb)
[ERROR] Can't read from printer (disconnected?) (SerialException): call to ClearCommError failed
[ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed (WindowsError(5, 'Access is denied.'))
(here i plug the usb cable back )
The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49
The progress should be updated on the printer now: M117 26.44% Est 1:49:49

thats all no error ???

any help pls?
Post edited by coolt5 on

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    That is very very strange... something has gone wrong somewhere then.. can you cancel the print from pronterface? When it stops, are the motors still "active" or do the axis become floppy? The fans keep spinning and the nozzle stays hot?

    Sorry - your post went to spam before. Shouldn't happen again for you.
  • coolt5coolt5 Posts: 38🌟 Super Member 🌟
    find out the x stepper driver was bad and replace it now its work good
  • Samuel PinchesSamuel Pinches Posts: 2,997Administrator
    👏 nice work! 👍
Sign In or Register to comment.