Home JGAurora A5 & A3S Getting Started & Troubleshooting

Print Troubleshooting

So after correcting a shift issue, I printed this tall tower to verify it was corrected.  Using a "fine" profile in cura to slice it.  The shifting is gone and overall it is OK except the front edge has a rough edge.  Only the front facing edge.  I am not sure what this symptom is called and thus makes it difficult to research a correction.  Attached is a print and the g-code file...

Comments

  • Laser8302Laser8302 Posts: 170Member, 🌟 Super Member 🌟
    Looks like Z-seam? Try a different method of Z-seam alignment? I think there's a few options in Cura to adjusts where the Z-seam is.
Sign In or Register to comment.