Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
LCD Firmware update doesn't start
FreddyGaertner
Posts: 11Member
Hi
I'm Freddy and this is my first thread.
Today i received my new A5 and started printing right away without major problems other than slight bed adhesion issues, so i wanted to enable Mesh Leveling.
I followed the guide on the wiki page to update the LCD firmware to the custom one but when i insert the SD card and turn on the printer it doesn't start updating and starts up normally
I already have flashed Marlin 1.1.8
The SD card is a SanDisk Extreme 128GB formatted to exFAT (I also tried formatting it to NTFS)
I apreciate any help
Thanks
I'm Freddy and this is my first thread.
Today i received my new A5 and started printing right away without major problems other than slight bed adhesion issues, so i wanted to enable Mesh Leveling.
I followed the guide on the wiki page to update the LCD firmware to the custom one but when i insert the SD card and turn on the printer it doesn't start updating and starts up normally
I already have flashed Marlin 1.1.8
The SD card is a SanDisk Extreme 128GB formatted to exFAT (I also tried formatting it to NTFS)
I apreciate any help
Thanks
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!