Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
No new user registrations are accepted. For more info, please click here.
Print speeds
Richy_T
Posts: 142🌟 Super Member 🌟
Has anyone done any calibration on the print speeds on these printers? My estimates by Cura seem to be way off, sometimes the actual print time is as much as double. I know there are acceleration factors etc but it still seems quite far out.
But even taking that into account, I am currently printing the bottom layers on a model and it is filling them with straight lines. The top/bottom speed is 30mm/s which is 3cm/s which should be quite fast yet it is visibly slow. Is there something going on with the speeds?
I'll note that this is with Octoprint. I'll have to give it a try directly from the SD card too but that shouldn't really make a difference since the print head is not stalling.
But even taking that into account, I am currently printing the bottom layers on a model and it is filling them with straight lines. The top/bottom speed is 30mm/s which is 3cm/s which should be quite fast yet it is visibly slow. Is there something going on with the speeds?
I'll note that this is with Octoprint. I'll have to give it a try directly from the SD card too but that shouldn't really make a difference since the print head is not stalling.
Comments
Howdy, Stranger!
RegisterIt looks like you've been lurking for a while.
If you register, we will remember what you have read and notify you about new comments. You will also be able to participate in discussions.
So if you'd like to get involved, register for an account, it'll only take you a minute!